| 796lss | |
| Line Shaft Converging Spur Module | |
 |
|
| 796lss | |
| Line Shaft Converging Spur Module | |
|
|
| SPECIFICATIONS | ||
| TREAD ROLLERS: 1.9"
dia. x 16 ga. steel, model 196S grooved, 3" centers. DRIVE BELT: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive. DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft. NOTE: Spools in spur section only are keyed to provide positive drive (designed not to slip on drive shaft). COUPLINGS: Couplings located both ends or one end only. Specify where couplings required. BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. Short side of spur is always 12" overall length. |
BEARINGS: Precision, lubricated, ball bearing units with composite housings. FLOOR SUPPORTS: SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor. MOTOR DRIVE: Unit is designed to be driven by 796LS. ROLLER CHAIN: Spur driven via crossover with No. 40 chain. |
|
|
NOTE: Specify "right hand" or "left hand". To determine hand of spur, refer to technical section. |